4/12/2023 0 Comments G boom speaker manual![]() For best reception please place the unit close to a window or open area to improve reception quality. NOTES: G-BOOM3 features a built-in internal FM antenna. Repeat this process until the desired station appears on the LCD display. The tuner will search and stop on the next strongest station signal it finds. For auto tuning, press and hold the TUNE-UP or TUNE DOWN button until the display starts to scan, then release the button.For manual tuning, repeatedly press the TUNE-UP or TUNE DOWN button to manually adjust the tuning on the LCD display until the desired station appears.The current FM station and FM icon will appear on the display. With G-BOOM3 powered “ON”, press the FM RADIO button.NOTE: If inserting audio cable into the Line-In Jack, G-BOOM3 will change to Line-In mode automatically regardless of the current input source. To switch to Radio, press the FM Radio button once and G-BOOM3 will enter FM Radio mode. When the G-BOOM3 powers “ON”, the default audio input source is Bluetooth. The LED ring will flash 1, 2 or 3 times when the EQ button is pressed to indicate preset EQ1, EQ2 or EQ3 respectively. Press the EQ Button repeatedly to cycle through them. ![]() Charge the rechargeable battery at least biannuallyĮQ1 = (Default) Dynamic: full bass and crisp high frequencies.ĮQ2 = Deep: Added emphasis on bass and low mids frequencies.ĮQ3 = Bright: Added emphasis on mids, vocals and high frequencies.Rechargeable batteries have a limited number of charge cycles.Actual battery life varies with use, settings, and environmental conditions.The battery is internal and cannot be replaced.When the G-BOOM3 battery is low, the red LED Charging indicator will begin flashing to warn you to recharge your G-BOOM3 for continued use and enjoyment. The red LED charging light on G-BOOM3 will illuminate to indicate charging process and turn off when the battery is fully charged. Use only the supplied AC adapter with the following spec: AC In – 100-240V AC, 50/ 60Hz / DC Out – 12V 1.5AĬonnect the supplied AC adapter to the DC IN Jack on the back of G-BOOM3 and plug the other end into a standard wall outlet to being automatically recharging the built-in battery. NOTES: Disconnect both ends of the AC adapter when not in use. PACKAGE CONTENTS:Ĭonnect the supplied AC adapter (DC 12V 1.5A) to the DC IN Jack on the back of G-BOOM3 and plug the other end into a standard wall outlet (100~240V 50-60Hz). Specications are subject to be updated without notice.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |